-
SIGNUP
- E-mail Address:
- errors go here
- |
- MY ACCOUNT
Home technology Sunglass Technology Interchangeable Tech
Sunglass Technology
Interchangeable Instructions
technology-instruction-for-the-interlock
To remove a lens:
A) Hold the sunglass facing you, with both hands on the temples.
B) Simultaneously rotate both temples 90 degrees inward. This will activate the Interlock system and open the frame. C) Remove the lenses and replace with desired lens this.
To insert a lens:
To close the Interlock system, rotate the temples back to the original position.
technology-instruction-for-the-V-TI
To remove a lens:
A) Hold the sunglass facing toward you with one hand on the lens and the other on the frame. Slowly pull the frame and lens apart in the upper corners on the lens.
B) Once the hooks have been released from both site of the lens, pull the lens up and out of the nose groove.
To insert a lens:
C) Place the lens in the center of the nose groove from the top of the sunglass. Push up on the outer corners of the lens until the lens hooks snap into the frame. Clean the lens with a Smith Smudgebuster.
technology-instruction-for-all-sliders-(threshold,-toaster)
To remove a lens:
With the sunglass facing toward you, hold the frame by the nose bridge. Grasp the lens between your palm and your index and middle finger.
Slide the lens firmly and slowly in an upward motion, rotating it from the inside outward.
To insert a lens:
Reverse the sequence. Place the outer ridge of the lens in the corresponding frame slot and slowly press down on the top edge of the lens until it slides firmly into place.
technology-instruction-for-all-rimless-(parallel,-redline,-factor)
To remove a lens:
With the sunglass facing toward you, hold the frame in the center between the lenses. Pull the lens firmly and slowly in a downward motion away from the center of the sunglass.
To insert a lens:
Place the outer edge of the lens in the lens grove and gently slide it into the frame until it locks in place above the nose.

